Teufelberger OP 85cm - 10mm Hitch Cord

Teufelberger OP 85cm e2e, 10mm Hitch cord, For use with KT282 Kit

• PLEASE NOTE: For compliance labelling reasons, Hitch Cords must be sourced from ISC (via your ISC Retailer). Hitch cords which are purchased through the Teufelberger supply network do not bear the required labelling, for compliance with the Rope Wrench PPE Regulation Approved kits.

Testing Data

All configurations of the adjustment device and ropes fulfilled the requirements. It was possible to descend with all systems and to adjust the speed manually by the user. The dynamic tests showed a comparable result for all configurations. The test mass was held by the system after all dynamic tests. The brake distance was below 1m. All configurations withstand a static force of at least 12kN without slipping. With higher forces it is possible that the adjustment device slips along the rope but stops again without any additional manual action. The force of 15kN was held for 3 minutes. The ‘Rope Wrench System’ fulfills all health and safety requirements of the PPE Regulation 2016/425 when setup and used according to the instructions for use.

During testing a maximum weight of 120kg was used to meet the requirements of the testing including maximum impact forces. In the event of higher weights being used, it is possible for higher impact forces to be imparted on the user, and it is their responsibility to limit any fall distances that could generate these higher forces.

Certification

KT282- System fulfils the health and safety requirements of PPE Regulation (EU) 2016/425
Notified Body having carried out the EU type test (Module B): TÜV AUSTRIA SERVICES GMBH (0408), Deutschstraße 10, 1230 WIEN, Austria

Notified body responsible for production monitoring and inspection (Module D):SGS Fimko Oy (0598),Takomotie 8 Helsinki, 00380.Finland.